Hobbs Roof Pros provides professional fascia & soffit in Hobbs, NM for residential and commercial properties across southeastern New Mexico. Fascia fails differently in a dry county. Elsewhere it rots. Here it is taken apart by ultraviolet light, and the sequence starts with the paint film rather than with water, which is why so much Hobbs fascia looks sound from the street and crumbles under a screwdriver.
The order goes like this. Sun breaks down the coating, the coating chalks and lets go, bare wood grain raises and checks, and then the two or three real rain events each year drive water straight into those checks with nothing to stop it. Between storms it dries completely, so nothing smells and nothing stains, and the board keeps failing quietly for a decade.
That means the useful inspection is of the finish, not the wood. When we look at eaves we are checking whether the paint is still bonded on the south and west elevations, whether nail heads have backed out and broken the film, and whether the fascia has separated from the rafter tails at the joints. Catch it there and it is paint. Miss it and it is carpentry.
The pre-1980 cohort mostly has wood eaves, often with vented panels that have been painted shut across four repaint cycles until no air moves through them at all. We open them back up or replace them with vented panels sized to a real net free area, because that intake is what makes the exhaust on the other end of the attic do anything.
The newer cohort has its own version of the same failure. Vinyl and aluminum soffit installed quickly during the last boom often sits with blown insulation pushed right up against the back of it, so the vent holes are decorative. We pull a panel, check it, and install baffles at the eave to hold a clear channel where the insulation keeps sliding down. Blocked intake is the reason a ridge vent above it does nothing at all.
Where we replace, we prefer a solid primed board with a full paint system on all six faces before it goes up, or an aluminum wrap over sound wood where an owner wants to stop painting. Both are legitimate. The wrap hides future problems, so we recommend it only after opening enough of the eave to know nothing is hiding behind the metal. Wrapping a failing board is a five-year decision dressed as a twenty-year one.
Our licensed and insured team brings the right materials and equipment to every job — open metal valleys formed in 26-gauge Galvalume, high-temperature synthetic underlayment rated for hot decks, caliche fines cleared from scuppers and downspout boots, granule-surfaced SBS cap sheet set in cold adhesive, unvented roof assemblies built with above-deck polyiso, mechanically seamed Galvalume panels riding on expansion clips — and backs the work with a written workmanship warranty. We serve Hobbs and nearby communities including North Hobbs, Lovington, Eunice, Jal.
What We Handle
Everything our fascia & soffit in Hobbs covers
One crew, one point of contact, and the full range of fascia & soffit work in Hobbs, NM. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia repair Hobbs NM
- soffit replacement Lea County
- rotted fascia board repair Hobbs
- vented soffit installation
- wood fascia UV damage New Mexico
- aluminum fascia wrap Hobbs NM
- soffit vent blocked insulation
- eave repair Lovington NM
- fascia and soffit cost Hobbs
- bird and rodent soffit entry
- soffit repair Eunice NM
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Hobbs services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with open metal valleys formed in 26-gauge Galvalume, high-temperature synthetic underlayment rated for hot decks, caliche fines cleared from scuppers and downspout boots, granule-surfaced SBS cap sheet set in cold adhesive, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Hobbs job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in southeastern New Mexico means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Hobbs
Hobbs Roof Pros covers Hobbs and the surrounding communities of southeastern New Mexico. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in North Hobbs, NM — Lea County, population 6,529
- Fascia & Soffit in Lovington, NM — Lea County, population 11,668
- Fascia & Soffit in Eunice, NM — Lea County, population 3,056
- Fascia & Soffit in Jal, NM — Lea County, population 2,202
- Fascia & Soffit in Tatum, NM — Lea County, population 706
- Fascia & Soffit in Monument, NM — Lea County, population 213
Start on the Hobbs Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Hobbs Chooses Hobbs Roof Pros
- ✓We price the roof around the decade the house was built, because two thirds of Hobbs predates 1980 and the deck under it varies block by block.
- ✓Deck repair is a named unit price in the estimate rather than a change order discovered on the second morning of a tear-off.
- ✓We will talk you out of a coating, a claim, a skylight or a full gutter wrap when the honest answer is to spend nothing.
- ✓Material comes from Midland, Lubbock or El Paso, so we order before tear-off and plan the schedule around the real wait.
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Hobbs follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Hobbs gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Hobbs, or request a quote and we'll get right back to you.