Hobbs Roof Pros provides professional chimney & wall flashing in Hobbs, NM for residential and commercial properties across southeastern New Mexico. Flashing is where nearly every roof in Hobbs eventually gives up, and the reason is the daily temperature swing rather than the annual rainfall. Sealant that would live for years in a mild climate is being stretched and compressed here every single day.
Follow a typical failure. A chimney was flashed with a bead of caulk laid against brick instead of a metal counterflashing cut into a joint. Forty degrees of swing between afternoon and dawn works that bead until it separates at the top edge. Nothing happens for months because it does not rain, and then one August cell puts water behind it and into a bedroom ceiling.
Our fix is mechanical rather than chemical. Base flashing and step flashing woven into the courses, counterflashing in two pieces, its upper leg saw-cut into a mortar bed joint and locked, with sealant demoted to a secondary line that carries no load. Done that way, the detail survives the swing because nothing structural depends on an adhesive. We also check what is still connected below a chase before quoting.
Past roughly thirty inches of width, a chimney earns a framed and metal-clad saddle on its uphill face, sized to the full width. Water arriving in the volume this county delivers in ten minutes does not trickle around an obstruction, it stacks against it. A flat dead space behind a chimney is also where dust accumulates and cements, and a cricket removes the place where that starts.
Wall terminations matter as much as chimneys and get less attention. Where a roof dies into a stucco or brick wall we run step flashing behind the finish, form a kickout at the lower end to throw water into the gutter or clear of the wall, and counterflash above. Missing kickouts are behind a large share of the wall staining we are called out to look at.
Not everything called a chimney here is one. Gas heat and mild winters mean many of these penetrations are metal flue chases, B-vents, and chase covers, some abandoned in place when a furnace changed. An unused chase is a hole with a lid, and the cheapest honest answer is often to remove it and deck over the opening rather than reflash something nothing is venting. A live flue is not something to guess at from the roof.
Our licensed and insured team brings the right materials and equipment to every job — open metal valleys formed in 26-gauge Galvalume, high-temperature synthetic underlayment rated for hot decks, caliche fines cleared from scuppers and downspout boots, granule-surfaced SBS cap sheet set in cold adhesive, unvented roof assemblies built with above-deck polyiso, mechanically seamed Galvalume panels riding on expansion clips — and backs the work with a written workmanship warranty. We serve Hobbs and nearby communities including North Hobbs, Lovington, Eunice, Jal.
What We Handle
Everything our chimney & wall flashing in Hobbs covers
One crew, one point of contact, and the full range of chimney & wall flashing work in Hobbs, NM. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing repair Hobbs NM
- chimney leak roof Lea County
- counterflashing reglet chimney
- chimney cricket saddle installation
- wall to roof flashing repair Hobbs
- kickout flashing stucco wall
- chimney chase cover replacement
- flue and B vent flashing Hobbs NM
- chimney repair Lovington NM
- roof to wall leak Eunice NM
- flashing repair Hobbs NM
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Hobbs services.
Materials, equipment and how we do chimney & wall flashing
The difference between chimney & wall flashing that lasts and chimney & wall flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with open metal valleys formed in 26-gauge Galvalume, high-temperature synthetic underlayment rated for hot decks, caliche fines cleared from scuppers and downspout boots, granule-surfaced SBS cap sheet set in cold adhesive, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Hobbs job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in southeastern New Mexico means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney & wall flashing outside Hobbs
Hobbs Roof Pros covers Hobbs and the surrounding communities of southeastern New Mexico. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney & Wall Flashing in North Hobbs, NM — Lea County, population 6,529
- Chimney & Wall Flashing in Lovington, NM — Lea County, population 11,668
- Chimney & Wall Flashing in Eunice, NM — Lea County, population 3,056
- Chimney & Wall Flashing in Jal, NM — Lea County, population 2,202
- Chimney & Wall Flashing in Tatum, NM — Lea County, population 706
- Chimney & Wall Flashing in Monument, NM — Lea County, population 213
Start on the Hobbs Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Hobbs Chooses Hobbs Roof Pros
- ✓We price the roof around the decade the house was built, because two thirds of Hobbs predates 1980 and the deck under it varies block by block.
- ✓Deck repair is a named unit price in the estimate rather than a change order discovered on the second morning of a tear-off.
- ✓We will talk you out of a coating, a claim, a skylight or a full gutter wrap when the honest answer is to spend nothing.
- ✓Material comes from Midland, Lubbock or El Paso, so we order before tear-off and plan the schedule around the real wait.
The standards behind chimney & wall flashing
Quality here is not a matter of opinion — it is written down. The chimney & wall flashing work we do in Hobbs follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney & wall flashing project in Hobbs gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney & wall flashing free estimate in Hobbs, or request a quote and we'll get right back to you.